Enclave FWD V6-3.6L (2008)
5. Release the wheel speed sensor wire grommet (1) from the wheelhouse.
6. Carefully pull the wheel speed sensor wire and connector (2) through the wheel house.
7. Release the wheel speed sensor wire harness routing clip (3) from the wheel house.
8. Release the wheel speed sensor wire harness routing clips (4) and (5) from the suspension strut.
Important: Clean the wheel speed sensor mounting area on the steering knuckle of any accumulated dirt and debris.
9. Remove the wheel speed sensor bolt.
10. Pull the wheel speed sensor straight up and out of the steering knuckle.
Installation Procedure
