Enclave FWD V6-3.6L (2008)
23. Tighten the intake and exhaust camshaft position actuator bolts. Use an open end wrench on the hex cast into the camshaft in order to prevent
engine rotation when tightening the camshaft position actuator bolts. Verify that the paint marks on the timing chain and camshaft position
actuators are aligned.
Tighten
Tighten the bolts to 58 Nm (43 lb ft).
24. Install the intake and exhaust camshaft position actuator solenoid valves and bolts.
Tighten
Tighten the bolts to 10 Nm (89 lb in).
25. Install the intake and exhaust camshaft position sensors and bolts.
Tighten
Tighten the bolts to 10 Nm (89 lb in).
26. Connect the engine wiring harness electrical connectors to the intake and exhaust camshaft position (CMP) sensors and actuator solenoid valves.
