Enclave FWD V6-3.6L (2008)
Engine Block Heater: Service and Repair
Coolant Heater Cord Replacement
Coolant Heater Cord Replacement
Removal Procedure
1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
2. Disconnect the coolant heater power supply cord from the coolant heater.
3. Lower the vehicle.
4. Disconnect the coolant heater cord clips (3) from the cylinder heads.
5. Disconnect the coolant heater cord clip from the engine wiring harness.
6. Remove the coolant heater cord (1) from the vehicle.
Installation Procedure
