Enclave FWD V6-3.6L (2008)
4. Place the crankshaft balancer in position on the crankshaft.
5. Thread the J 41998-B in the crankshaft. Ensure you engage at least 10 threads of the J 41998-B before pressing the crankshaft balancer in place.
6. Push the crankshaft balancer into position by tightening the nut on the J 41998-B until the large washer bottoms out on the crankshaft end.
7. Remove the J 41998-B .
8. Install the crankshaft balancer bolt.
Notice: Refer to Fastener Notice .
9. Tighten the crankshaft balancer bolt.
1. Tighten the crankshaft balancer bolt to 100 N.m (74 lb ft).
2. Tighten the crankshaft balancer bolt an additional 150 degrees using the J 45059 .