Enclave FWD V6-3.6L (2008)
Camshaft: Service and Repair
Camshaft Replacement - Right Side
Camshaft Replacement - Right Side
Tools Required
*
EN-48313 Timing Chain Retention Tool
*
EN 46111 Crankshaft Rotation Socket
Removal Procedure
1. Remove the lower intake manifold. Refer to Lower Intake Manifold Replacement (See: Intake Manifold/Service and Repair) .
2. Remove the camshaft cover. Refer to Camshaft Cover Replacement - Right Side (See: Cylinder Head Assembly/Valve Cover/Service and
Repair/Camshaft Cover Replacement - Right Side) .
3. Remove the camshaft sensors. Refer to Camshaft Position Sensor Replacement - Bank 1 (Right Side) Exhaust and Camshaft Position Sensor
Replacement - Bank 1 (Right Side) Intake .
4. Remove the intake camshaft position actuator solenoid. Refer to Camshaft Position Actuator Solenoid Valve Solenoid Replacement - Bank 1
(Right Side) Intake .
5. Remove the crankshaft balancer. Refer to Crankshaft Balancer Removal (See: Service and Repair/Overhaul) .
6. Rotate the crankshaft with the EN 46111 until the camshafts are in a neutral (low tension) position. The camshaft flats will be parallel with the
camshaft cover rail (1).