Enclave FWD V6-3.6L (2008)
Important:
*
Ensure that the marks on the camshaft position actuator and the timing chain (1-4) are aligned.
*
DO NOT tighten the camshaft position actuator bolt at this time.
1. Locate the camshafts to the cylinder head and assemble the camshaft actuators to the camshafts.
2. Install the camshafts and the camshaft bearing caps. Refer to Camshaft Installation - Left Side (See: Service and Repair/Overhaul) .
3. Remove the EN-48313 .
Notice: Refer to Torque Reaction Against Timing Drive Chain Notice .
Important: Use an open-end wrench at the camshaft hex to prevent camshaft/engine rotation.
4. Install and tighten the camshaft position actuators. Refer to Camshaft Position Actuator Installation - Left Side Intake (Fourth Design) (See:
Service and Repair/Overhaul) and Camshaft Position Actuator Installation - Left Side Exhaust (Fourth Design) (See: Service and Repair/Overhaul
) .
