Enclave FWD V6-3.6L (2008)
7. Raise the vehicle.
8. Install the nuts that secure the auxiliary HVAC module to the vehicle.
Notice: Refer to Fastener Notice.
Tighten the nuts to 9 N.m (80 lb in).
9. Install the air conditioning lines (4, 5) and the nut (6) to the auxiliary HVAC module.
Tighten the nut to 16 N.m (12 lb ft).
10. Install the heater lines (2, 3) to the auxiliary HVAC module at the underside of vehicle.
11. Install the right rear wheelhouse liner panel.
12. Lower the vehicle.
13. Fill the engine coolant. Refer to Cooling System Draining and Filling (Vac N Fill) Cooling System Draining and Filling (Static Fill).
14. Recharge the refrigerant to the system. Refer to Refrigerant Recovery and Recharging.
15. Leak test the fittings of the component using the J 39400-A.
