Enclave FWD V6-3.6L (2008)
6. Remove the discharge line to condenser bolt (1).
7. Disconnect the discharge line from the condenser (3).
8. Remove the discharge line.
9. Remove the A/C pressure switch.
10. Remove and discard the discharge line O-rings (2).
Installation Procedure
1. Install new O-rings to the discharge line (2).
2. Install the A/C pressure switch.
3. Connect the discharge line to the condenser (3).
Notice: Refer to Fastener Notice.
4. Install the discharge line to condenser bolt (1).
Tighten the bolt to 9 N.m (80 lb in).