Enclave FWD V6-3.6L (2008)
Notice: Do Not handle the fuel sender assembly by the fuel pipes. The amount of leverage generated by handling the fuel pipes could damage the
joints.
10. Remove the fuel tank module lock ring (1).
11. Slowly raise the module (2) until the fuel level sensor float arm is just visible.
Important: When removing the module from the fuel tank, be aware that the module reservoir bucket is full of fuel. The module must be
tipped slightly during removal to avoid bending the fuel level sensor float arm.
12. Tilt the module towards the lower front corner of the fuel tank to allow the level sensor float arm to clear the tank opening. Remove the module
from the fuel tank.
13. Carefully discard the fuel in the module reservoir bucket into an approved container.
14. Remove and discard the fuel tank module seal (3).
15. Remove the fuel level sensor, if required.
Important:
*
Some lock ring were manufactured with DO NOT REUSE stamped into them. These lock rings may be reused if they are not damaged
or warped.
*
Inspect the lock ring for damage due to improper removal or installation procedures. If damage is found, install a NEW lock ring.
*
Check the lock ring for flatness.
