Enclave FWD V6-3.6L (2008)
8. Remove the power steering cooler pipe from the vehicle.
Installation Procedure
1. Install the power steering cooler pipe to the vehicle.
2. Install a new power steering cooler pipe clamp (2).
3. Connect the power steering cooler pipe to the power steering gear outlet hose (4,3).
Notice: Refer to Fastener Notice .
4. Install the power steering gear outlet hose bracket bolt (1).
Tighten the bolt to 8 N.m (71 lb in).
5. Connect the power steering cooler pipe (3) to the power steering fluid cooler (1) and tighten the power steering cooler pipe clamp (2).
6. Clean any excess fluid from the vehicle and remove the drain pans.