Enclave FWD V6-3.6L (2008)
Fuse: Diagnostic Aids
Connector Repairs
Connector Repairs
Connector Repairs contains a list of all connector repairs. The connector repairs are listed by the connector manufacturer and then by connector type. If
the technician cannot identify the manufacturer of the connector, refer to Identifying Connectors below. Knowing the connector manufacturer will assist
in finding the correct connector repair from the following list:
*
Connector Position Assurance Locks
*
Terminal Position Assurance Locks
*
Bosch Connectors (BSK) Bosch Connectors (0.64) Bosch Connectors (2.8 JPT) Bosch Connectors (ECM)
*
Delphi Connectors (Weather Pack) Delphi Connectors (Push To Seat) Delphi Connectors (Pull To Seat) Delphi Connectors (Micro-Pack 100W)
Delphi Connectors (Micro.64) Delphi Connectors (12-Way)
*
Tyco/AMP Connectors (CM 42-Way) Tyco/AMP Connectors (Sensor) Tyco/AMP Connectors (0.25 Cap) Tyco/AMP Connectors (43-Way)
Tyco/AMP Connectors (Door Module)
*
Yazaki Connectors (2-Way) Yazaki Connectors (16-Way)
*
Repairing Connector Terminals
Connector Anatomy
1 - Connector Positive Assurance (CPA)
2 - Assist Lever
3 - Wiredress Cover
4 - Seal Strain/Relief
5 - Slide Left Hand
6 - Slide Right Hand
7 - Terminal Positive Assurance (TPA)
8 - Terminal Positive Assurance (TPA)
9 - Connector Seal
10 - Connector Housing
11 - Inner Connector
Identifying Connectors
Knowing the connector manufacturer is helpful when trying to locating the correct connector repair procedure. There are many different connector
designs used on GM vehicles and it is sometimes difficult to identify the connector manufacturer. The information in this document should help with the
identification of connector manufactures.
The following connector manufacturers make most of the connectors found in GM vehicles:
