Enclave FWD V6-3.6L (2008)
7. Remove the J 45722 (1) from the fuel tank module lock ring.
8. Connect the fuel sender wiring harness electrical connector (3) to the fuel tank module.
9. Connect the fuel sender wiring harness electrical connector (2) to the fuel tank pressure sensor.
10. Position the fuel pump fuel feed line and the EVAP canister vent front pipe to the fuel tank.
11. Connect EVAP canister vent front pipe quick connect fitting (4) to the fuel tank module.
12. Connect the fuel pump fuel feed line quick connect fitting (1) to the fuel tank module.
13. Install the fuel tank.