Enclave FWD V6-3.6L (2008)
5. Locate the intake camshaft position actuator to the camshaft and loosely install the bolt.
Important: Camshaft thrust washers must be installed on all 2007-2008 applications when servicing the camshaft position actuators, even if not
originally equipped with thrust washers
6. Install the camshaft thrust washer.
Notice: A wrench must be used on the hex of the camshaft when loosening or tightening in order to prevent component damage. Failure to prevent
the torque reaction against the timing drive chain can lead to timing drive chain failure.
Important: Use an open-end wrench at the camshaft hex to prevent camshaft/engine rotation.
7. Tighten the camshaft position actuator bolt. See: Engine, Cooling and Exhaust/Engine/Service and Repair/Overhaul/Repair Instructions/104.
Camshaft Position Actuator Installation - Right Side Intake
8. Install the right exhaust camshaft actuator. See: Camshaft Position Actuator Replacement - Bank 1 (Right Side) Exhaust
