Enclave FWD V6-3.6L (2008)
Notice: Refer to Torque Reaction Against Timing Drive Chain Notice .
15. Use an open end wrench on the hex cast into the right intake and exhaust camshafts and rotate the camshafts towards each other in order to create
slack in the chain between the actuators.
16. The EN-48313 is now properly installed to hold the timing chain in position.
Important: Ensure that the camshaft timing chain and the camshaft position actuators are marked for proper assembly.
17. Mark the timing chain and the respective locations on camshaft position actuators (15-18).
18. Remove the camshaft position actuator bolt.
19. Remove the camshaft bearing caps and the camshaft. Refer to Camshaft Removal - Right Side (See: Service and Repair/Overhaul) .
Installation Procedure
