Enclave FWD V6-3.6L (2008)
Fuel Tank Unit: Service and Repair
Fuel Tank Module Replacement
Tools Required
J 45722 Fuel Sender Lock Ring Wrench
Removal Procedure
Caution: Whenever fuel line fittings are loosened or removed, wrap a shop cloth around the fitting and have an approved container available
to collect any fuel.
Notice: Clean all fuel pipe and hose connections and surrounding areas before disassembling to avoid possible contamination of the fuel system. Spray
the fuel pump module cam-lock ring tang with penetrating oil prior to attempting removal.
Important: A NEW fuel tank module seal is necessary each time the fuel tank module is serviced. Obtain a NEW seal prior to beginning this
service procedure.
1. Remove the fuel tank.
2. Disconnect the fuel pump fuel feed line quick connect fitting (1) from the fuel tank module.
3. Disconnect evaporative emission (EVAP) canister vent front pipe quick connect fitting (4) from the fuel tank module.
4. Reposition the fuel pump fuel feed line and the EVAP canister vent front pipe out of the way.
5. Disconnect the fuel sender wiring harness electrical connector (2) from the fuel tank pressure sensor.
6. Disconnect the fuel sender wiring harness electrical connector (3) from the fuel tank module.
