Enclave FWD V6-3.6L (2008)
Camshaft Position Sensor: Diagnostic Aids
Tyco/AMP Connectors (Sensor)
Tyco/AMP Connectors (Sensor)
Tools Required
J-38125 Terminal Repair Kit
Terminal Removal Procedure
1. Disconnect the connector from the component.
2. Insert the J 38125-11A (GM P/N 12094430) tool into the cavity on the lower right hand face of the connector until the terminal release tang access
panel slides over.
3. Ensure that the terminal release tang access panel is in the correct location to access the terminals.
4. Push the wire side of the terminal that is being removed toward the connector and hold it in position.
