Enclave FWD V6-3.6L (2008)
Both driver and passenger seats must be repaired when this concern occurs even if only one DTC code is set. The service kit contains sufficient
components to repair both seat connectors.
Connector Replacement
Tools Required
-
J-38125-7, Crimp Tool
-
J-38125-6, Crimp Tool
Note
The service kit shown above includes harness and connector clips, which are not required in this installation.
Replace connectors on both driver and passenger seats, and then reposition the connectors following the steps below.
1. Disable the SIR system. Refer to SIR Disabling and Enabling in SI.
Note
Only use hand tools to remove the seat to floor mounting bolts. If there are any problems with bolt removal, refer to Corporate Bulletin Number
10-08-50-002.
2. Remove the driver's seat to floor mounting bolts. Loosen the seat from the front retainers and tilt it back to expose the underside of the seat. Refer
to Front Seat Replacement - Bucket in SI.
3. Disconnect the seat to body harness connector (1). Disconnect the seat airbag connector (2).
