Enclave FWD V6-3.6L (2008)
3. Disconnect the seat to body harness connector (1). Disconnect the seat airbag connector (2).
Note
Note the wire colors on the seat airbag harness and body harness. Ensure that the wire colors are matched when installing into the new connector.
4. Cut both wires from the body harness connector and seat airbag harness connector as close to the connector housing (1) as possible to minimize
wire length loss. Slide the conduit away on the seat airbag harness and remove just enough tape on the body harness to access the wires to install
the terminals and seals.
Note
Use caution when stripping insulation. Take care not to cut through the wire strands.
5. Slide the wire seals onto all four leads back enough to enable removal of the insulation. Install the blue seals (1) on the body harness and the white
seals (2) on the seat airbag harness. Strip the insulation off all four leads 5 mm (3/16 in). Align the seals with the wire insulation.
