Enclave FWD V6-3.6L (2008)
2. Ensure that the service loop (2) faces towards the front of the seat.
3. Insert the taped-on gray clip into the round attachment hole (3) as shown in the illustration.
4. Attach the existing black clip to the new seat suspension location (4).
Attach Passenger Side Harness to Seat
1. Insert the connector retainer clip into the rectangular attachment hole (1) on the passenger seat as shown in the illustration.
2. Ensure that the service loop (2) faces towards the front of the seat.
3. Insert the taped-on gray clip into the round attachment hole (3) as shown in the illustration.
4. Attach the existing black clip to the new seat suspension location (4).
Reinstall Seats
1. Make the connections between the seat airbag harness and the body harness.
Note
Apply medium strength Loctite (blue) to bolts before installing.
2. Install both the driver and passenger seats. Refer to Front Seat Replacement - Bucket in SI.
3. Move the seat to the maximum forward position and raise the seat to its maximum height.
4. Using a flash light, locate the air bag and body wire harnesses.
5. Secure the air bag harness (2) to the body harness (3) using a tie strap (4) as shown in the illustration. The air bag harness (2) is secured to the
body harness (3) approximately 100 mm (3.9 in) from the back of the air bag connector (1).
6. Remove excess tie strap with wire cutters.
7. Enable the SIR system. Refer to SIR Disabling and Enabling in SI.
8. Turn the ignition on and use the diagnostic tool to clear the SDM DTCs and verify that the issue has been corrected. If the code is still current,
refer to the appropriate diagnostic procedure found in SI.
2008 Model Year Buick Enclave, GMC Acadia and Saturn OUTLOOK Vehicles Only
Note
The seat mounted side impact airbag connection to the body harness is located at the forward edge of the seat, below the plastic trim. The connectors are
yellow. The body harness wires are exposed - running forward in the vehicle, down through the carpet cutout in the floor.
