Enclave FWD V6-3.6L (2008)
2. Disconnect connector C308 (1) from under the driver's seat cross-beam. The connector is accessible from the rear of the seat (2).
Note
Only use hand tools to remove the seat to the floor mounting bolts. If there are any problems with bolt removal, refer to Technical Service Bulletin
10-08-50-002.
3. Remove the driver's seat. Refer to Front Seat Replacement - Bucket in SI.
Note
Note the wire colors on the seat airbag harness and body harness. Ensure that the wire colors are matched when installing the new connector.
4. Cut both wires from the body harness connector and seat airbag harness connector as close to the connector housing (1) as possible to minimize
wire length loss.
Note
The SIAB harness conduit is yellow on the Chevrolet Malibu. The SIAB harness conduit is black on the Pontiac G6.
5. Slide the conduit away and remove the tape (1).
Caution
Use caution when stripping insulation. Take care not to cut through the wire strands.
6. Slide the wire seals onto all four leads, back enough to enable removal of the insulation. Install the blue seals on the body harness and the white
seals on the seat airbag harness. Strip the insulation off all four leads 5 mm (3/16 in). Align the seals with the wire insulation.
7. On the body harness, position two FEMALE terminals onto the wires. Caution must be used not to position the wire too far forward as it may
interfere with the mating portion of the terminal. Crimp the terminals onto the bare wire using the J38125-7 crimp tool, Jaw E (1). Repeat the
procedure using two MALE terminals on the seat airbag harness.
