Enclave FWD V6-3.6L (2008)
8. Position the wire seal to the terminal and crimp the seal and insulation using the J38125-6 crimp tool, Jaw 1 (1).
Warning
DO NOT use soldering equipment that is battery or electric powered. These types of soldering irons can induce voltage into the circuit, which may cause
inflator module deployment and/or damage to electrical components. Use only the EL-28125-5 Ultra Torch or another butane fueled soldering iron when
working on SIR circuits.
Note
Avoid getting solder on the terminal end or overheating the terminal.
9. Solder all four terminals at the wire crimp.
10. Slide the two seat airbag harness terminals through the opening of the orange connector position assurance (CPA) (1).
Note
Ensure that the appropriate wire colors match up (as noted in NOTE above Step 4) when the connection is made between the seat airbag harness
and body harness.
11. Slide all four terminals (2) into the appropriate connector body as shown in the illustration. Install the blue terminal position assurance (TPA)
devices onto the connector ends.
12. Install the gray connector clip onto the appropriate connector body.
13. Add NyoGel 760 lubricant (dielectric lubricant) to the terminals on both sides of the connections.
14. Wrap Woven Polyester Electrical Tape (PET) (preferred) or equivalent anti-abrasion tape or electrical tape around the two exposed wires on the
seat harness for a length of 30 mm (1.2 in) from the back of the connector. Continue to wrap the tape around the back of the connector.
15. Slide the conduit back up. Wrap tape starting at the back of the connector and over the conduit for a length of 130 mm (5 in).
16. Tape on the gray clip at 110 mm (4.33 in) from the back of the connector. Note that the clip orientation should be in line with the retainer clip
orientation on the connector.
17. Repeat the above procedure on the passenger seat.
Attach Driver's Side Harness to Seat
1. Insert the connector retainer clip into the rectangular attachment hole (1) on the driver seat as shown in the illustration.
