Enclave FWD V6-3.6L (2008)
Steering Shaft: Service and Repair
Intermediate Steering Shaft Replacement
Intermediate Steering Shaft Replacement
Removal Procedure
Notice: Secure the steering wheel utilizing a strap to prevent rotation. Locking of the steering column will prevent damage and a possible
malfunction of the SIR system. The steering wheel must be secured in position before disconnecting the following components:
*
The steering column
*
The intermediate shaft
*
The steering gear
After disconnecting these components, do not move the front tires and wheels. Failure to follow these procedures may cause improper alignment
of some components during installation and result in possible damage to the SIR coil.
1. Turn the steering wheel to the straight forward position and lock it in place.
2. Hoist the vehicle and raise it. Refer to Lifting and Jacking the Vehicle .
3. Disengage the intermediate steering shaft boot from the steering gear and the intermediate steering shaft upper seal.
4. Remove the intermediate steering shaft bolt (1) and separate the intermediate steering shaft from the steering gear.
5. Remove the left side instrument panel insulator panel. Refer to Instrument Panel Insulator Panel Replacement - Left Side (Acadia) Instrument
Panel Insulator Panel Replacement - Left Side (Enclave) Instrument Panel Insulator Panel Replacement - Left Side (Outlook) .
