Enclave FWD V6-3.6L (2008)
6. Remove the intermediate steering shaft bolt (1) at the steering column, separate the intermediate steering shaft (2), and pull the intermediate
steering shaft upper seal (3) from its place.
Important: Spreading both ends of the new or removed intermediate steering shaft while out of the vehicle will help with the installation.
7. Remove the intermediate steering shaft from inside the vehicle.
Installation Procedure
1. Install the intermediate steering shaft from inside the vehicle.
Notice: Refer to Fastener Notice .
2. Install the intermediate steering shaft (2) to the steering column, install the intermediate steering shaft bolt (1), and install the intermediate steering
shaft upper seal (3) back in place.
Tighten the bolt to 22 N.m (16 lb ft).