Enclave FWD V6-3.6L (2008)
11. Install the upper mount.
12. Raise the suspension crossmember.
Important: If the suspension crossmember mount bolt does not screw in smoothly, run a tap through the frame crossmember nut in the
body in order to remove foreign material. Ensure the tap does not punch through the underbody.
Do not over tighten the body mount. Over tightening may collapse a spacer or strip a bolt.
Notice: Refer to Fastener Notice.
13. Install the suspension crossmember to body bolts.
Tighten the bolts to 110 N.m (81 lb ft) plus 90 degrees.
14. Remove the jackstands.
