Enclave FWD V6-3.6L (2008)
2. Install the control solenoid valve body and TCM assembly (5).
3. Rotate the control solenoid valve spring (7) into position.
Notice: Refer to Fastener Notice .
Important: Install all bolts before tightening, then tighten in specified sequence.
4. Install the 4 control valve body bolts (1) M6 x 80.
5. Install the control valve body bolt (6) M6 x 55.
6. Install the 3 control valve body bolts (2) M6 x 95.
7. Install the control valve body bolt (3) M6 x 42.
8. Install the 2 control valve body bolts (4) M6 x 65.
Tighten the bolts in sequence to 12 N.m (106 lb in).
9. Connect the input speed sensor electrical connector (1).
10. Connect the output speed sensor electrical connector (2).
