Enclave FWD V6-3.6L (2008)
3. Protect the floor carpet panels on both sides of the console base with absorbent towels to prevent staining from the liquid cleaner used in the
following steps (1).
4. Locate the stepped selector section and detent spring on the shifter assembly (Acadia, Enclave and OUTLOOK automatic transmission control
shown (1)).
5. Clean the sticky residue from the surfaces of the stepped selector section and detent spring on the shifter assembly using the cleaner listed below.
Keep the direct spray away from electrical components. Using a small brush, go over all of the working surfaces of the stepped selector and detent
spring to loosen and remove all residue.
6. After thoroughly cleaning the components, wipe off the liquid with an absorbent towel.
7. A small amount of compressed air may be helpful to assist in drying the components and surrounding area. Use care not to spread the liquid on to
adjacent interior components.
8. Verify the performance of the mechanical and electrical components after the cleaning procedures.
9. Reinstall the components removed in step 1.
10. Thoroughly inspect the console base area and carpet for residue and clean as required.
Parts Information
Warranty Information
For vehicles repaired under warranty, use the table above.
Disclaimer