Enclave FWD V6-3.6L (2008)
5. Put a light coat of grease from the service kit on the bearing roller grooves of the inner race and outer race.
6. Hold the inner race 90 degrees to centerline of cage with the lands of the inner race (1) aligned with the windows of the cage (2) and insert the
inner race into the cage.
7. Hold the cage and inner race 90 degrees to the center line of the outer race (1) and align the cage windows (3) with the lands of the outer race.
Important: Be sure that the retaining ring side of the inner race faces the wheel drive shaft bar.
8. Place the cage and the inner race into the outer race.
9. Insert the first bearing roller, then tilt the cage in the opposite direction to insert the opposing bearing roller.
10. Repeat this process until all 6 bearing rollers are in place.
11. Install the CV joint retaining ring to the wheel drive shaft bar.
12. Place approximately half the grease from the service kit inside the outboard seal and pack the CV joint with the remaining grease.
