Enclave FWD V6-3.6L (2008)
Washer Fluid Heater: All Technical Service Bulletins
Windshield Washer Solvent Heater Removal
WINDSHIELD WASHER SOLVENT HEATER REMOVAL
1. Disconnect the windshield wiper solvent inlet and outlet hoses (1) from the windshield washer solvent heater assembly and from the two plastic
inlet and outlet windshield wiper solvent hoses.
Note
Do NOT remove the connector retention clips from the connectors. Do NOT remove the assembly bracket from the engine compartment.
2. Disconnect the two electrical connectors at the windshield washer solvent heater assembly.
3. Remove the windshield washer solvent heater assembly from the assembly bracket using a small flat blade screwdriver.
4. Place the windshield washer solvent heater assembly on a work bench.
5. Cut the two-wire connector from the windshield washer solvent heater assembly. Vary the length of the red and black wires on the connector.
Refer to illustration.
