Enclave FWD V6-3.6L (2008)
11.
Clean the motor shaft splines (1) with a wire brush to remove any residue. If there is any glue or epoxy residue on the shaft thread, remove as
much material as possible. Do NOT use any chemical or cleaning agent, or any tool other than a manual wire brush.
Shaft Conditions
12.
After cleaning the motor shaft, check the physical characteristics of the shaft splines (teeth) and thread. Both should be clean and free from any
damage or deformations. If deformations are present, the motor is to be discarded and a new one is to be used.
13.
Prior to re-assembly of the wiper module, check for any contamination or dirt on the sockets. Make sure that the grease is clean and present on all
the sockets and ball studs.
