LaCrosse V6-3.6L (2007)
Locate the yellow and white pair of terminal wires (driver's side) or twisted tan and green pair of terminal wires (passenger's side).
Cut the twisted pair of wires (2) at the door harness tape location (1)
Route the new side impact sensor harness (1) through the tubular grommet (2).
Remove the terminal positive assurance (TPA) from the connector (2).
Remove the cut twisted pair of wires from the connector cavities. Note the cavity locations for the yellow and white wires (driver's side) or tan and green
wires (passenger's side).