LaCrosse V6-3.6L (2007)
Carefully peel back the water deflector (2) to expose the inner door and window regulator rail (1). If the energy absorber block is attached to the window
regulator rail, remove it. Retain the energy absorber block and fasteners for reinstallation in Step 19.
Determine if there is a side impact sensor and side impact sensor harness. Note the routing of the side impact sensor harness.
If the side impact sensor (SIS) harness is routed on the inboard side of the impact beam and around the inner door flange area, perform Steps
17-24.
If the vehicle is not equipped with the side impact sensor and SIS harness, or the SIS harness is routed along the inboard and outboard side of the side
impact beam, no further action is required. Refer to the Claim Information section of this bulletin. Submit a claim for Door Inspection - No Repair
Required.
Remove the side impact sensor harness from the vehicle.
Removal of the side impact sensor (3) from the door sensor bracket (2) is required on the passenger's side of the vehicle.
Remove the connector position assurance connector (1) from the side impact sensor (3).
Disconnect the side impact sensor (3) from the harness connector.
Remove the side impact sensor harness fasteners from the door impact beam and inner door flange area.
