LaCrosse V6-3.6L (2007)
9. Remove the retaining clip and disconnect the cable from the clevis.
10. Use a 13 mm box-end wrench to release and remove the cable from the bracket on the pedal assembly.
11. Remove the park brake pedal assembly.
Installation Procedure
1. Install the park brake assembly onto the body mounting studs.
Notice: Refer to Fastener Notice.
2. Install the 3 park brake pedal assembly retraining nuts.
Tighten the nuts to 25 N.m (18 lb ft).
3. Install the front park brake cable into the bracket on the park brake pedal assembly.
4. Insert the cable button into the clevis and install the retaining clip.
5. Connect the electrical connector to the park brake switch.
6. Reposition the carpet properly.
7. Install the left side front carpet retainers and the lower center pillar trim panel on the left side.
8. Install the left side closeout/insulator panel.
9. Raise and support the vehicle. Refer to Vehicle Lifting.
10. Install the front park brake cable through the park brake cable guides.
