LaCrosse V6-3.6L (2007)
2. Install the heater core cover to the HVAC module assembly.
Notice: Refer to Fastener Notice.
3. Install the heater core cover screws (2).
Tighten all screws to 1.5 N.m (13 lb in).
4. From the inside of the heater air outlet cover, drill the dimples adjacent to the heat stakes using a 5.5 N.m (7/32 in) drill bit.
5. Install the heater air outlet cover.
6. Install the heater air outlet cover screws (2)
Tighten the screws to 1.5 N.m (13 lb in).
7. Connect the rear floor air outlet duct to the heater air outlet cover.
8. Install the rear floor air outlet duct to the holes in the floor reinforcement.
9. Install the communication interface module.
10. Install the floor carpet.
11. Install the RH instrument panel closeout/insulator panel.
12. Install the LH instrument panel closeout/insulator panel.
