LaCrosse V6-3.6L (2007)
*
Theft System Not Programmed
*
Trunk Open
*
Turn Signal On
For more information on the DIC warning messages refer to Indicator/Warning Message Description and Operation.
Trip Odometer Button
The trip odometer button is used to access the Odometer, Trip Distance A and B. Average Speed and Time Elapsed modes are also available in the
uplevel DIC.
Odometer
The odometer is capable of displaying values from 0 to 999,999 miles or kilometers. If the ignition is in the OFF or ACC position, the odometer can be
displayed by pressing the trip button. The odometer will remain displayed for 5 seconds. If the ignition is in the OFF position, the odometer will also be
displayed for 15 seconds.
Trip Odometer A and B
The DIC can display Trip A or Trip B odometers. The trip odometers are capable of displaying values from 0 to 99999.9 miles or kilometers. When the
maximum value of 99999.9 miles or kilometers is reached, the trip odometer will roll over to 0.0 miles or kilometers. To reset the trip odometer, press
the Set/Reset button. If the Set/Reset button is held for three seconds, it will perform a retro-active reset. This feature is used to display the total
number of miles accumulated on a trip since the last ignition cycle.
Average Vehicle Speed (AVS)
The DIC displays the average speed of the vehicle in mph or km/h. The average speed displayed is the cumulative average of the vehicle speed since the
last reset.
Elapsed Time
The timer is displayed as XX (hours) : XX (minutes) : XX (seconds). The timer status and data value is retained in memory when the ignition is turned
OFF. When the ignition is ON again, the timer status and data value is resumed. The timer maximum value is 99:59:59. When the maximum is reached,
the timer rolls over to 00:00:00 and continues. The timer can start, stop, and continue by pressing Set/Reset. The Set/Reset button is pressed and held for
three seconds to reset the timer to zero.
Information Button
The options button is used to access the Personalization mode in the DIC. It will also access the Date, Language, Display Units, Daytime Display
Enhancements, Engine Oil Monitor System, Tire Inflation Monitor System, and Compass Calibration modes (uplevel only).
Language Selection
The language of the DIC can set to English, French, or Spanish by pressing the Set/Reset button. Once the preferred language is chosen, the options
button is pressed to move to the next mode.
English/Metric Unit Selection
The units of the DIC and other vehicle displays can be set to English or Metric by pressing the DIC Set/Reset button. Once the preferred units are
chosen, the options button is pressed to move to the next mode.
Compass Re-Calibration/Compass Zone Selection
The DIC compass is self -calibrating. However, the compass may need to be recalibrated once it travels outside a specific geographic zone. For compass
calibrations and zones refer to: Electronic Compass Calibration in Instrument Panel, Gages, and Console.
Personalization Programming Options
The DIC will customize a number of driver preferences. For complete details on Personalization: Refer to the Owner's Manual for more information.
Set/Reset Button
This button is used to set or reset values within the trip odometer, average economy or options mode. Refer to the descriptions to find out which items
can be reset.
Gages Button (Uplevel DIC)
