LaCrosse V6-3.6L (2007)
Turn Signal Switch: Service and Repair
Turn Signal Multifunction Switch Replacement
Turn Signal Multifunction Switch Replacement
Removal Procedure
Caution: Refer to Restraint System Service Precautions.
1. Disable the SIR system.
2. Remove the upper and lower trim covers.
Important: The abrasion sleeve located on the steering column wire harness assembly must be reinstalled. Make note of what connector is
coming out of the abrasion sleeve for installation purposes.
3. Remove the wire harness assembly (1) from the wire harness strap (2).
4. Disconnect the turn signal and multifunction switch assembly connector from the SIR system coil connector.
5. Slide the 2 connectors (2) of the turn signal and multifunction switch assembly out of the bulkhead connector (1).
6. Remove the 2 pan head tapping screws (1) and (3) from the turn signal and multifunction switch assembly (2).
7. Remove the turn signal and multifunction switch assembly (2) from the steering column tilt head assembly.
