LaCrosse V6-3.6L (2007)
9. Disconnect the I/P wiring harness connector from the junction block.
10. Disconnect the forward lamp wiring harness connector from the junction block.
11. If accessory wiring junction block retainer removal is necessary, perform the following:
1. Release the positive battery cable lead retainers from the junction block retainer, then reposition the cable lead away from the retainer.
2. Remove the nut retaining the junction block retainer to the strut tower.
3. Lift the junction block retainer to release the lower tab and remove the retainer from the vehicle.
Installation Procedure
Notice: refer to Fastener Notice in Service Precautions.
1. If accessory wiring junction block retainer installation is necessary, perform the following:
1. Position the junction block retainer to the strut tower and insert the lower tab on the retainer to the slot on the tower.
2. Install the junction block retainer to strut tower nut.
Tighten the underhood accessory wiring junction block retainer to strut tower nut to 3 N.m (27 lb in).
3. Position the positive battery cable lead end through the slot in the junction block retainer, then secure the cable retainers.
