LaCrosse V6-3.6L (2007)
1. Position the throttle body heater inlet hose/pipe to the engine.
2. Connect the throttle body heater inlet hose to the throttle body.
Notice: Refer to Fastener Notice.
3. Install the bolts securing the throttle body heater inlet hose/pipe to the following:
*
The intake plenum (2)
*
The engine rear lift bracket
Tighten the throttle body heater inlet hose/pipe bolts to 9 N.m (80 lb in).
4. Connect the vacuum brake booster hose (3) to the vacuum source.
5. Connect the following to the front of the throttle body heater inlet hose/pipe:
*
The CMP sensor connector
*
The left knock sensor connector
*
The vacuum pipe retainer
6. Connect the electrical connector (2) to the coil pack (1).
7. Connect the throttle body heater inlet hose to the water crossover, using 90 degrees needle nose pliers.
