LaCrosse V6-3.6L (2007)
The new side impact sensor harness can be installed on either front door. The twisted pair of wires at the terminal end of the new harness is the same
color (yellow and white) as the old side impact sensor wire harness on the driver's side door. When installing the new side impact sensor harness on the
passenger door, insert the yellow wire in the cavity that the tan wire was removed from (C5). Insert the white wire in the cavity that the green wire was
removed from (C4). When installing the new side impact sensor harness on the driver door, insert the yellow and white wires in the same cavities as the
old yellow (C5) and white (C4) wire were removed from.
Install the twisted pair of wires from the new side impact sensor harness into the correct connector cavities.
Install the connector TPA.
Route the sensor end of the side impact sensor harness through the door panel grommet hole. Ensure the excess slack from the SIS harness is pulled
through the grommet and into the door.
Top view
Tape Location and Door Harness
