LaCrosse V6-3.6L (2007)
14. Hand tighten the Timing Chain Retention Tool. If installed correctly, there should be a small amount of slack in the timing chain between the
camshaft position actuator sprockets.
15. The Timing Chain Retention Tool is now properly installed to hold the timing chain in position.
Tip
It is not necessary to completely remove the camshaft actuator from the engine in order to install the thrust washers.
16. Remove the intake camshaft position actuator bolt.
17. Move the camshaft position actuator forward enough to slip the camshaft thrust washer over the front of the intake camshaft and position it against
the cylinder head.
18. Position the intake camshaft actuator to the camshaft and install the actuator bolt hand tight. If necessary, slightly rotate the camshaft to engage the
timing pin.
19. Remove the exhaust camshaft position actuator bolt.
20. Move the camshaft position actuator forward enough to slip the camshaft thrust washer over the front of the exhaust camshaft and position it
against the cylinder head.
21. Position the exhaust camshaft actuator to the camshaft and install the actuator bolt hand tight. If necessary, slightly rotate the camshaft to engage
the timing pin.
22. Remove the Timing Chain Retention Tool EN-48313.
