LaCrosse V6-3.6L (2007)
4. Remove the centering tab (1) and discard.
Notice: Gently pull on the lower coil assembly wire in order to remove any wire kinks inside of the column assembly. Verify that there are NO
kinks or bends in the SIR coil assembly wire. If a kink or bend is present, interference may occur with the shaft lock mechanism. Turning the
steering wheel may cut or damage the wire.
5. Install the SIR steering wheel module coil retaining ring. Verify that the ring (1) is firmly seated in the groove on the upper shaft (2).
6. Route the wire harness assembly around the steering column tilt head.
Install a wire strap around the wire harness assembly and through the hole on the steering column tilt head assembly.
7. Install wire harness straps to the wire harness assembly.
8. Install the steering column trim covers.
9. Enable the SIR system. Refer to SIR Disabling and Enabling.
