LaCrosse V6-3.6L (2007)
SIS Wires, Driver's Side Shown; Passenger's Side Similar
Bottom View
Tape Location and Door Harness
SIS Wires
Grommet Tab, Passenger's Side Shown, Driver's Side Similar
Completely wrap the SIS (2) wires and door harness (1) together with at least two wraps of electrical tape from the tape location on the door harness (1)
to a point 25 mm (1 in) rearward of the tape location. Rearward of the tape location is toward the inside of the door panel. Forward of the tape location is
toward the door harness connector. Ensure that the SIS wires and door harness are taped together on the same side of the grommet tab (3). Do not tape
the SIS wires over the grommet tab (3).
Insert the door grommet into the door panel.
Secure or connect the lever lock connection.
Install the black rubber tubular grommet into the A-pillar.
Route and fasten the new side impact sensor harness along the inboard and outboard side of the impact beam (3) using the four SIS harness fasteners.
The first fastener (1) on the terminal side of the SIS harness must be installed on the inboard side of the impact beam (3). The remaining three fasteners
must be installed on the outboard side of the impact beam (3). Callout (1) in the illustration shows a fastener installed on the inboard side of the impact
beam (3). Callout (2) in illustration shows a fastener installed on the outboard side of the impact beam (3).
Install the connector position assurance connector from the side impact sensor.
Connect the side impact sensor to the side impact sensor harness connector.
