LaCrosse V6-3.6L (2007)
Fluid Line/Hose: Service and Repair
Transmission Fluid Cooler Hose/Pipe Connector Replacement
Transmission Fluid Cooler Hose/Pipe Connector Replacement
Removal Procedure
Notice: Allow sufficient clearance around the transaxle oil cooler pipes and around the hoses to prevent damage or wear which may cause
fluid loss.
1. Raise and support the vehicle. Refer to Vehicle Lifting.
2. Position a drain pan under the vehicle.
3. Remove the oil cooler hoses from the transaxle oil cooler fittings.
4. Remove the oil cooler fittings (28,29) from the transaxle.
Installation Procedure
Notice: Refer to Fastener Notice in Service Precautions.
Important: The correct thread engagement is critical. Cross-threaded fittings can achieve proper tightness and still leak.
1. Install the oil cooler fittings (28,29) to the transaxle.
Tighten the fittings to 38 N.m (28 lb ft).
2. Install the oil cooler hoses to the transaxle oil cooler fittings.
3. Lower the vehicle.
Notice: Refer to Transmission Overfill Notice in Service Precautions.
4. Adjust the fluid level.
5. Inspect for fluid leaks.
6. Remove the drain pan from under the vehicle.
