LaCrosse V6-3.6L (2007)
Torque Converter Clutch Solenoid: Diagnostic Aids
Connector Repairs
Connector Repairs
Connector Repairs contains a list of all connector repairs. The connector repairs are listed by the connector manufacturer and then by connector type. If
the technician cannot identify the manufacturer of the connector, refer to Identifying Connectors below. Knowing the connector manufacturer will assist
in finding the correct connector repair from the following list:
* Connector Position Assurance Locks
* Terminal Position Assurance Locks
* Bosch Connectors (0.64) Bosch Connectors (2.8 JPT) Bosch Connectors (BSK) Bosch Connectors (ECM)
* Delphi Connectors (Micro.64) Delphi Connectors (Micro-Pack 100W) Delphi Connectors (Pull To Seat) Delphi Connectors (Push To Seat)
Delphi Connectors (Weather Pack) Delphi Connectors (12-Way)
* Tyco/AMP Connectors (025 Cap) Tyco/AMP Connectors (CM 42-Way) Tyco/AMP Connectors (Sensor) Tyco/AMP Connectors (43-Way)
Tyco/AMP Connectors (Door Module)
* Yazaki Connectors (2-Way) Yazaki Connectors (16-Way)
* Repairing Connector Terminals
Identifying Connectors
Knowing the connector manufacturer is helpful when trying to locating the correct connector repair procedure. There are many different connector
designs used on GM vehicles and it is sometimes difficult to identify the connector manufacturer. The information in this document should help with the
identification of connector manufactures.
The following connector manufacturers make most of the connectors found in GM vehicles:
* AFL/EPC (Alcoa Fujikura Ltd./Engineered Plastics Components)
* Bosch
* Delphi
* FCI (Framatome Connectors International)
* JAE (Japan Aviation Electronics)
* JST (Japan Solderless Terminals)
* Kostel
* Molex
* Sumitomo
* Tyco/AMP
* Yazaki
Identifying the manufacturer of a connector is often difficult. When trying to determine the manufacturer of a connector, look for specific identifying
marks that are unique to that connector supplier. Most of these identify marks are hard to find or see. Check the connector carefully and refer to the
information below for pictures and descriptions of connector identification markings.
* Most of AFLs connectors have EPC on their connector body. Some of the smaller connectors will not have any markings on them.
