LaCrosse V6-3.6L (2007)
5. Loosen the bolts and separate the dies.
6. Check swaged ring (2) for any lip deformities. If present, place the ring (2) back into the J 41048 making sure the ring covers the whole swaging
area. If necessary, re-swage the ring.
Notice: Refer to Fastener Notice in Service Precautions.
7. Crimp the eared clamp (1) using the J 35910, a breaker bar, and a torque wrench.
Tighten the eared clamp to 136 N.m (100 lb ft).
8. Check the gap dimension, continue tightening until the gap dimension is reached.
