LaCrosse V6-3.6L (2007)
9. Put a light coat of grease from the service kit on the ball grooves of the inner race and the outer race.
10. Hold the inner race 90 degrees to centerline of cage with the lands of the inner race (1) aligned with the windows of the cage (2) and insert the
inner race into the cage.
11. Hold the cage and the inner race 90 degrees to centerline of the outer race (1) and align the cage windows (3) with the lands of the outer race.
Important: Be sure that the retaining ring side of the inner race faces the halfshaft bar.
12. Place the cage and the inner race into the outer race.
13. Insert the first chrome ball then tilt the cage in the opposite direction to insert the opposing ball.
14. Repeat this process until all 6 balls are in place.
15. Place approximately half the grease from the service kit inside the outboard seal and pack the CV joint with the remaining grease.
