LaCrosse V6-3.6L (2007)
4. Apply 12.7 mm wide x 1.52 mm thick (1/2 in x.060 in) double sided tape, such as 3M P/N 06397, to the glass frame base. Position the tape along
the ridge at the rear edge as shown (1).
5. Install the seal removed from the original molding onto the new service part. The seal should clip on - no adhesive is required.
6. Remove the protective film from the double sided tape and install the new molding. Apply firm hand pressure to ensure that the molding is making
full contact with the double sided tape.
Parts Information
Warranty Information
For vehicles repaired under warranty, use the table above.
Disclaimer
