LaCrosse V6-3.6L (2007)
Rear Door Window Regulator: Service and Repair
Rear Side Door Window Regulator Replacement
Removal Procedure
1. Remove the rear door trim panel.
2. Remove the rear door water deflector.
Notice: refer to Paint Damage Notice.
3. Raise the window far enough in order to gain access through the inner door panel to the window guide retainer clips.
4. Push inward on the window guide retainer clip locks, lift upward on the window until released from the retaining clip.
5. Raise the window to the full up position and tape in place.
6. Disconnect the electrical connector from the power window motor.
7. Loosen the bolt to the window regulator motor (2, 3, 4).
8. Lift the motor free of the retaining slot.
9. Remove the window regulator and motor from the door.
10. Remove the power window motor from the window regulator.
Installation Procedure
1. Install the power window motor to the window regulator.