LaCrosse V6-3.6L VIN 7 (2006)
3. Install the caliper (2) over the rotor and onto the caliper bracket (3).
4. Install the caliper pin bolts (1). The leading caliper pin bolt, or top bolt, has a bushing as part of the assembly. The trailing caliper pin bolt, or
bottom bolt, is a solid design. Ensure that the bolt boots fit securely in the groove of the caliper pin bolts. If the boots are damaged, they must be
replaced.
Tighten the bolts to 95 Nm (70 ft. lbs.).
Notice: Refer to Fastener Notice in Service Precautions.
Important: The leading caliper pin, or top bolt, has a bushing as part of the assembly. The trailing caliper pin, or bottom bolt, is a solid design.
5. Assemble the brake hose bolt (1) and the NEW copper brake hose gaskets (3) to the brake hose (2).
Important: Install NEW copper brake hose gaskets.
6. Install the brake hose-to-caliper bolt to the brake caliper.
Tighten the bolt to 54 Nm (40 ft. lbs.).
7. Remove the 2 wheel lug nuts retaining the rotor to the hub.
8. Install the front tire and the wheel assembly.
9. Lower the vehicle.
10. Fill the master cylinder to the proper level with clean brake fluid.
11. Bleed the brake system.
12. Inspect the hydraulic brake system for brake fluid leaks.
