LaCrosse V6-3.6L VIN 7 (2006)
NOTE: Always re-attach the fuel lines and fuel filter with all original type fasteners and hardware.
Do not repair sections of fuel pipes.
NOTE:
-
Secure the fuel pipes to the frame in order to prevent chafing. Maintain a minimum of 13 mm (1/2 inch) clearance around a pipe in order to
prevent contact and chafing. Maintain a minimum of 19 mm (3/4 inch) around any moving part.
-
Do not allow the fuel pipes to come into contact with the fuel tank or underbody.
IMPORTANT: If the fuel line attaching hardware is damaged or broken, replace the hardware.
2. Remove the caps from the fuel pipes.
3. Connect the fuel feed and EVAP pipes to the fuel tank.
4. Lower the vehicle.
5. Connect the fuel feed and EVAP pipes to the engine.
6. Lower the vehicle.
7. Tighten the fuel fill cap.
8. Reconnect the negative battery cable.
9. Inspect for fuel leaks with the following procedure:
1. Turn ON the ignition for 2 seconds.
2. Turn OFF the ignition for 10 seconds.
3. Turn ON the ignition.
4. Inspect for fuel leaks.
