LaCrosse V6-3.6L VIN 7 (2006)
7. Remove the park lock cable assembly (1) from the ignition lock cylinder case in the following way:
1. Use a small blade to push against the locking tab on the end of the park lock cable assembly (1).
2. Disconnect the park lock cable assembly (1) from the ignition lock cylinder case.
8. Remove the 3 TORX screws (2) from the ignition lock cylinder case (1).
9. Remove the ignition lock cylinder case (1) from the steering column tilt head assembly.
Installation Procedure
1. Align the ignition lock cylinder case (1) with the steering column tilt head assembly.
2. Notice: Refer to Fastener Notice in Service Precautions.
Screw the 3 TORX screws (2) into the ignition lock cylinder case (1).
^
Tighten the 3 TORX screws to 7 Nm (62 inch lbs.).
